Touch – Firmware update T11 for ALGIZ 10X V3

This firmware update for Algiz 10X V3’s touch includes adjustments of touch sensitivity against noise. Follow the steps below, to install the touch firmware update.

  1. Connect the unit to an AC charger.
  2. Download zip file (at bottom of this page) and extract it on Algiz 10X V3.
  3. Run eGalaxUpdate2.exe.
  4. Click button Load Image.
    windows settings
  5. Select the firmware file PCAP3160UI_2284_v00_T11_33x52_C000_PCAP_UI_DThqa.3160UI. This file is located in the same folder as eGalaxUpdate2.exe.
    windows settings
  6. Click button Go!
    windows settings
  7. Do not use the unit or click on the touch till firmware update is done. Below is how it looks when the update is running.
    windows settings
  8. When the update is done you’ll see a green status bar with text Firmware update Success. Check the touch version at Version under Current Controller.
    windows settings
  9. Click button OK.
  10. Done.
Was this article helpful?
No
Copyright © 2024 Handheld Group. All rights reserved.
Images, texts and other material downloaded from the Handheld web pages may not be reproduced in any form, without prior written permission from the Handheld Group.
Algiz® and Nautiz® are registered trademarks of Handheld Group AB. l Privacy Policy l Device Policy l GDPR l Legal l