GNSS: Change NMEA version to 4.10 on ALGIZ 10XR

To change the NMEA version to 4.10, follow the steps below.

  1. Open u-center.
  2. Connect to GPS module (default port is COM3, baudrate 9600):
  3. Go to View > Configuration View.
  4. Click NMEA (NMEA Protocol) on the left side list.
  5. At NMEA Version select the entry 4.10:
  6. Click the Send button in the lower-left corner:
  7. Switch to CFG (configuration) tab in left side list and select Save current configuration. At Devices: select all 4 list entries. (To select all entries, tap and hold pen/mouse on first entry and move down to last entry. Release pen/mouse). Then click the Send button in the lower-left corner:
  8. Click Receiver > Action > Save Config:

  9. Close u-center.
Was this article helpful?
No
Copyright © 2024 Handheld Group. All rights reserved.
Images, texts and other material downloaded from the Handheld web pages may not be reproduced in any form, without prior written permission from the Handheld Group.
Algiz® and Nautiz® are registered trademarks of Handheld Group AB. l Privacy Policy l Device Policy l GDPR l Legal